So you have installed your brand new slip yoke eliminator (SYE) on your transfer case and you just finished tightening...
Stu’s comment: Tim was good enough to take photos, make notes, and generally do everything else needed to document his...
If you have installed a suspension lift where you had to change out your control arms, you have done about 70% of an axle swap. Besides the control arms, you’ll need to remove the sway bar where it connects to the axle housing, the brake lines and housing vent fitting,...
Eventually there comes a time when you might need to remove an axle shaft from your D35c rear axle. Although...
I had finished up a week in Moab, wheelin’ with some friends, and I noticed that the front drive shaft...
The following information was posted on JU by Ryan, a forum contributor from West Virginia. When asked, he graciously agreed to let me add his comments to the drive shaft write-up. I had been hearing the angry sparrows from my front DS for a few weeks and finally got time to...
Two years ago, when the Toys by Troy Alumi-flex lift went on the TJ, I installed a Tom Wood rear...
Shortly after I had installed my Tom Wood front drive shaft, I came across an on-line forum thread that was started...
I had picked up a set of D-30 inner and outer axle shafts from a friend in California when we wheeled the Rubicon together. Having gone to 35″ tires during my last lift, I thought it would be prudent to carry a set, “just in case”. It seems that when...
Note: Steve was gracious enough to let me post his write-up on how to do a u-joint replacement. This came...